Catler FP 8010 - Manual (Page 11)

10
ASSEMBLING YOUR FOOD PROCESSOR FP 8010
5. Place the processing lid onto the
processing bowl so the feed chute is
slightly right of the bowl handle and the
arrow graphics are aligned
. Holding
the feed chute and pressing down fi rmly
at the same time, turn the lid clockwise (as
indicated by the graphic) so the ‘Locking
Tab’ on the lid slots into the ‘Interlocking
Safety Catch’ on the handle. The lid should
be securely locked into position.
Fig. 5
NOTE:
The food processor will not operate
unless both the processing bowl and
lid are correctly locked into position.
6. Insert the power plug into a 230/240 volt
power outlet and switch the power outlet
on.
7. Press the POWER/OFF button to turn
your food processor on. The red light
illuminates around the POWER /OFF
button to indicate that the processor is
on. Your food processor has POWER/OFF,
START/PAUSE and PULSE buttons to give
total control when processing food. Press
the START/PAUSE button to switch the
motor on and operate continuously.
NOTE:
The food processor will not start
unless the large food pusher is
inserted correctly into place.
Press the POWER/OFF button to switch
the motor off . When short bursts of
power are required, press the PULSE
button and hold down briefl y, release,
then press again. The PULSE action will
automatically stop when the button is
released.
8. To set the timer, press the buttons
located to the left of the timing window.
Time will move up by 5 second intervals,
from 0 to 30 seconds. From 30 seconds to
2 minutes the time will increase in
10 second intervals and from 2 minutes
to 9.59 minutes the time will increases in
20 second intervals.
9. Once the time is set, press the START/
PAUSE button and the timer will start to
count down.
Ensure the large food pusher is inserted
correctly into place. The food processor
will not start until pusher is in place.
Once the timer has fi nished, the food
processor will stop and go into ‘Standby’
mode. Three (3) beeps will be sounded to
indicate that the processing is complete.
The processor incorporates a ‘Safety
Interlock System’ that ensures the unit
will not start without the large food
pusher in position. Processing will stop
automatically, once the large food pusher
has been removed from the lid. The chute
max fi ll graphic indicates the maximum
volume of food to be placed in the chute
for the pusher to activate the unit.
CAUTION:
THE PROCESSING BLADE (INCLUDING THE MINI BOWL BLADE) AND DISCS ARE
EXTREMELY SHARP, HANDLE WITH CARE AT ALL TIMES.