Salter Brecknell 308BP - Manual (Page 6)

vi
CHAPTER 2: GETTING STARTED
After unpacking the scale, a small amount of preparation is required before the scale can be used. Please
refer to Figure 2-1 below as needed.
COM1 SERIAL
PORT (RS-232)
POWER
CONNECTOR
ON/OFF
SWITCH
Figure 2-1: 308-BP Back Panel
Step 1. Position the scale in its area of intended use. Observe the following guidelines for suitable
location.
1. Choose a firm, stable floor or table.
2. Do not share an AC outlet with electrical noise producing equipment, such as refrigeration
units. This includes products with electrical motors and/or relays.
3. Do not place the scale in an area with changing ambient temperature and/or high humidity.
4. Do not place the scale in an area prone to exposure to direct sunlight, wind, or dust.
5. Do not place the scale in an area with vibrating equipment.
NOTE: If you ordered the rechargeable battery option, use the AC adapter to recharge your battery
overnight if possible before using the scale for the first time. If this is not possible, use your AC adapter
during the scale’s first use and then leave it plugged in overnight.
Step 2. Install the AC Adapter.
1. After placing the scale in its area of use, locate the AC Adapter.
2. Connect the female end of the AC Adapter to the connector on the rear of scale, and then
plug the adapter into an AC outlet. Make sure that the AC voltage appearing at the wall
outlet matches the input voltage marked on the AC adapter.
Step 3. If applicable, install the serial printer.
1. Connect the printer to the 308-BP’s interface port using the optional serial cable.
2. Configure the printer’s communication parameters as detailed in Chapter 5.
Step 4. Turn the scale’s AC power on first, and then push the ON/OFF key on the front panel to begin
use.