B&M 80692 CONSOLE MEGASHIFTER - Manual (Page 4)

4
Figure #6
Check List
___ Ignition/steering column lock works cor-
rectly. Key can be removed and steer-
ing column locks when key is removed.
Step 4.
___ Cable is securely fastened to shifter
and end is held with E-clip. Step 6.
___ Cable is routed as shown in Figure 4 and
securely fastened to transmission and
swivel is held with cotter key. Step 12.
___ Shifter is properly adjusted. Step 13.
___ The neutral start and reverse light
switches are connected and properly
adjusted to prevent engine from starting
in forward gears and reverse. Step 14.
___ There is no debris in shifter mecha-
nism.
___ Cover plate is securely fastened and
shift position indicator is operating prop-
erly. Step 20.
___ Shifter moves freely in all positions as
described in Shifter Operation.
___ If your shifter is not working properly
do not attempt to drive your vehicle.
Make sure you have followed all in-
structions. If the shifter is broken or
defective return it to your B&M dealer.
14
5
9
12
13
Typical Pin
Number
8
IMPORTANT
Before installing the T-handle onto the
shifter put a little grease on the threads of
the stick. The aluminum of the T-handle
may gall on the threads of the stick and
make it impossible to remove the T-handle
from the stick. If this occurs it can cause
the stick to break if you use excessive
force while attempting to remove the T-
handle from the stick.
Figure #5
Tool List
1 Common Screwdriver
1 Phillips Screwdriver
1 #15 Torx bit or driver
1 10mm Wrench
1 1/4" Wrench
1 5/16" wrench
2 7/16" Wrench
1 9/16" Wrench
2 11/16" Wrench
1 10mm Socket and ratchet
1 1/8", 9/32" and 1/4" Drill Bits
1 Drill Motor
2/4 Jack Stands
1 0-50 lb.ft. Torque Wrench
1 File
1 Wire Stripper
1 Wire Crimper
1 Pliers
1 Electrical Tape
A/R Nylon Tie Wraps (to secure cable)
GM Transmissions
GM cable bracket (Trimming of bracket
required if used on cast aluminum pan)
Use these two holes for
TH-400 transmission. Use
other two holes for other
GM transmissions
Spacer
GM lever
GM cable bracket
Cable swivel
Cotter pin
(Use front hole)
5/16 x 1" bolt and spacer
(Metric trans use M8 x 25 bolt)
7/16" nut
F
C
R
GND
0 1
A1 A2
24
21
14
11
2
4
6
8
TYPICAL PIN
NUMBER
RELAY DPST
NORMALLY OPEN
12VDC
(SUPPLIED)