B&M 40227 TRANSPAK - Manual (Page 16)

Under normal circumstances, it should not be neces-
sary to alter or readjust the initial setting of the TV control
cable. Situations requiring readjustment of the TV control
cable include maintenance involving the removal and/or
replacement of the throttle body, transmission, TV cable
assembly or installing a new main control assembly.
Readjustment of the TV control cable would also be
necessary to correct complaints of poor transmission shift
quality that would have been caused by a misadjustment
of the TV control cable.
When the TV control cable is properly set, the trans-
mission TV control lever will be at its internal idle stop
(lever to rear as far as it will travel) when the throttle lever
is at its idle stop.
Idle Speed Affect on TV Control Cable
The 5.0L and 5.0L HO (302 CID) SEFI engine uses an Air
Bypass (ISC) that does not affect throttle position. There-
fore, idle automatic setting does not affect TV cable
adjustment.
6. Self-locking TV Cable Linkage Adjustment
6.1Remove air cleaner cover and inlet tube from throttle
body inlet to access throttle lever and cable assembly.
6.2Using a wide-blade screwdriver, pry grooved pin on
Figure 20
Figure 22 Figure 23
16
Figure 21