Alumax P-DRC1Y - Manual (Page 15)

15
10 STRAIGHT HANDLE
GASKETS INSTALLATION
11
Install straight handle (8) onto sliding door
(6). Ensure that clear washers on either side
of glass are installed.
11B
Install the door mid-gasket (9) to the door
panel (6) by way of a protective block and
mallet. Start from the bottom edge of the
door panel and work the gasket up. Ensure
that a 1/2’’ gap remains between the
running rail (1) and the top edge of the
mid-gasket (9) for clearance.
11A
12
10
1/2’’
INTERIOR
SHOWER SIDE
Thoroughly clean the edge of
the sliding door (6), closest to
the side where the handle is
located with a cloth and
degreasing solution . Apply
the door gasket (other half
of gasket from Step 1) (10) to
this edge of the sliding door (6).
8
6
9
6
6
6