Canon 150U - Manual (Page 6)

Loading and Removing the Film
■ Loading the Film
’I Open the back cover and load the
film.
• Push the back cover release lever
down.
^ Position the film correctly
between the film guides.
Film guides
/ (Oi;)
mo
l o a Q C o a a o n l \ ci i
3
Pull the film out to the
(film leader position indicator).
• Make sure that there is no slack in the
film when you pull it out.
• If the edge of the film leader goes
beyond the film leader position
indicator, rewind some of the film back
into the cartridge.
Close the back cover.
■►The film automatically winds on to the
first frame and “1” appears on the
frame counter.
• If the frame counter shows a blinking
“0”, the film did not load correctly. Load
the film again.
ISO 400 DX-coded film is recommended. The film^speed is set to ISO 25
when non-DX film is loaded. If the film does not have a DX-code, insert it
into the film compartment, close the back cover and press the shutter
button once or twice.
.(i j
1
■ Removing the Film
The film rewinds automatically when it
reaches the end.
When the film is fully rewound, the frame
counter shows “0” and the blinks. Then
open the back cover and remove the film.
• If the
©
is not blinking, press the button.
o If you take more pictures than stipulated on the filrn, the (ast frame is cut
during developing, and the date and time may not be Imprinted on the last
frame.