Canon 150U - Manual (Page 16)

Imprinting the Date ànd Time
^ Select the Date mode.
• With the power off, press the IMODEI
button.
^ Select the date and time
combination.
• By pressing the Dill button, you cant
select the date and time combination.
The display changes in the cycle
shown below.
p ->
■ *—
---------
Press the IMODEI button and the power
switches off.
Date/time etc. imprinted here.
■ Setting the Date and Time
When you replace the battery or travel to the different timp zone, use the
following procedure to set or adjust the date ancj tirne settings.
*1 Select the Date mode.
2 Press the [iM] button for more than
2 seconds for date/time set mode.
J Press the button to select the
setting position (numbers blinking).
• Setting position cycles through in the
order year-month-day-hour-minute-(:).
4 Press the CfU button to set the
number.
^ Repeat 3 and 4 above to set all
digits of the date and time.
• Pressing the II^II button while is blinking
resets the seconds (;) setting to zero.
^ Finish setting the date and time.
• Press the [♦♦♦] button and once stops
blinking, date and time setting is
completed.
• Press the IMODEI button and the power
switches off.
Setting the Date
-I-
Jnu- ;3n
u “ (U Cu
" I ''
-I-
, ''
nti_
U I i U t Z U
' «
íE-íSO-
r ^ ^
nti- O-Tin
U I (C €_u
^ I ''
Setting the Time
^ * Z '
-
HriPH
"
1 ''
▼
*
-
^ 1 ^
^
\
^
Each time the button is pressed, the number increases by one^ If kept
pressed, the number increases continuously. ''