Checking the battery – Canon AT 1 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Checking the Battery
If there is not sufficient voltage, the
camera will not function, so check the battery
as indicated below. The main switch is also
used when checking the battery. Turn the
main switch/battery check lever as far to the
left as possible or, in other words, to the "C"
index on the outer side of the film rewind
crank while looking into the viewfinder to see
if the power level is sufficient. If the meter
needle rests above the battery check index
mark, there is sufficient voltage. If it is below
the index mark, replace the battery as there is
not enough voltage left in the battery for the
camera to operate.
Perform a battery check in the follow
ing situations:
1.
When a battery is loaded.
2.
If the shutter does not function.
3.
When a great number of photographs
have been taken.
4.
When the camera is used after it has been
stored for a long period without use.
When the camera is used in extremely
cold conditions.
5.