Handling the lens cap, Mounting the lens – Canon AT 1 User Manual

Page 22

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Handling the Lens Cap

The lens cap can be removed from the

front of the lens after pressing in the tabs on
both sides of the cap. The rear dust cover can

be removed by turning the Canon Breech-

Lock ring in the direction of the arrow. To
attach the dust cover, align its slot with the

positioning pin below the red dot of the

Breech-Lock ring, and press it in. When the

dust cover is removed, the Breech-Lock

ring is locked.

Mounting the Lens

Remove the body cap. Make sure that the

aperture ring is not set to the "A" mark

before

mounting

the

lens.

Release

the

aperture ring from the "A" mark by pushing
the EE lock pin and turn the ring. Then,

mount the lens by aligning the red dot of the
body with the red dot of the bayonet ring,
and then turning the Breech-Lock ring clock

wise, pressing gently until it locks into

position. Reverse the procedure to dismount

the lens.