Nikon ML-3 Modulite Remote Control Set User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Point the transmitter in the direction of the

. • reoeption sensor and lightly press the

transmission button. The monitor light will light

up for a moment.

The reception indicator LED lights up for a

moment and the camera’s exposure meter turns
on. If the camera’s focus mode is set to C,

focus detection starts immediately.

Fully depress the transmission button. It takes
approx. 3 seconds to take a picture.

The reception indicator LED starts blinking

rapidly and continues blinking until a picture is

taken.

• To cancel operation during a delayed-

shooting interval, set the receiver’s
power/channel selector switch to OFF.

Pre-shooting focus detection:

A focus

detection signal is not sent during the delayed-
shooting interval. Be sure to lightly press the

transmission button to secure focus before

actual shooting.