Nikon ML-3 Modulite Remote Control Set User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

I'ou should also replace
catteries If the LED starts
clinking after it lights up.

Notes:
• Power/channel selector switch setting on the

receiver must coincide with the channel

selector setting on the transmitter. Otherwise,

power does not turn on. (The receiver

operates in either CHI or CH2 setting when

the channel selector setting on the transmitter

is at A. TRIG.)

• As both transmitter and receiver are

controlled by microprocessors, sometimes
they may fail to operate even with fresh,
correctly installed batteries. In this case, turn

the power switch OFF for a few seconds, then

ON again.