Sony GV-500 - Manual (Page 62)

Hecotding wHh CCD-G1
Insert the cassette.
2
Set POWER of this unH to CAMERA.
The power of this unit is tumdd on, and the POWER lamp
lights. This unit automatically becomes in the recording
pause mode. To have the picture on the screen of this unit
press LCD ON/OFF.
Note
Check that the POWER lamp lights.
If you leave the unit in the recording pause mode for 5
minutes or longer, the unit will be automatically turned off.
To resume the recording pause mode, slide POWER to the
right once, then reset POWER to the CAMERA position
While pressing the
green button, slide
POWER to the left
pa fER
.vnottorr
3
start recording.
Press REC START/STOP of the camera.
To index the recording starting point or the desired point, press MARK of this unit,
(seepage 51.)
To stop recording for a moment
Press REC START/STOP of the camera. Press it again to start recording.
To stop recording
Turn the power off of this unit by setting POWER to the center position.
Playing back the newly recorded pictures
1
Turn the power on of this unit. While pressing the green —
The POWER lamp lights. button, slide POWER to the
right.
\l/
PO\«R
u* I -^vmbNiorr
2
Press of this unit to rewind the tape.
3
Press □ of this unit.
Press > of this unit
Caution
Do not operate this unit for long periods if heat cannot easily escape. Internal heat build-up may
occur which can cause the unit to malfunction.
When the POWER switch is set to CAMERA, the operable buttons are:
POWER switch, EJECT button, LCD ON/OFF button, DATA SCREEN button, COUNTER
2
RESET button, INDEX MARK button, and SP/LP recording time selector.