Sony SLV-779HF - Manual (Page 10)

step 3: Hookups (continued)
AIM
hookup: VCR setup
After you've connected your TV and completed antenna or cable hookup,
use the following procedure to set up the VCR.
Press MENU and select
ADVANCED OPTIONS.
Set AUTO ANT SELECT
to OFF and press OK.
ADVANCED OPTIONS
AUTO StERE.
TUNER AUDIO
APC
TAPE SELECT
AUTO TAPE SPEED
SHARPNESS
Z5RETURN
SELECT
SET
QUIT
№
b S zz
L-M- -H
For details, see page 84.
Caution
Connections between the VCR's VHF/UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure
to do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
cormect the output of the VCR to an antenna or make simultaneous (parallel) anterma
and VCR cormections at the anterma terminals of your receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CA'TV system installer's attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
1 0 I Getting Started