Cable box connections, Cable box, Cable box and cable – Sony WEGA KV-36FS10 User Manual
Page 10: L h !(. l u : i a
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

) l h !(. L u : i a
S
i
. , .
a; I / u ' / 1
1 c ' ' I ‘ ; , /(r’l.i
Cable Box Connections
Some pay cable TV systems use scrambled or
encoded signals that require a cable box to
view all channels.
Cable box
1
Connect the coaxial connector from your
cable to the IN on your cable box.
2
Using a coaxial cable, cormect OUT on
your cable box to VHF/UHF on your TV.
If you will be controlling all channel selection
through your cable box, you should consider
using the CHANNEL FIX feature, (see page 23).
Cable
IN
% ^
OUT
(Rear of TV)
VHF/UHF
Cable box
Cable box and cable
For this set up, you can switch between
scrambled channels (through your cable box),
and normal (CATV) channels by pressing
ANT on your remote control.
Notes
• Your Sony remote control can be
programmed to operate your cable box,
(see page 31).
* When using PIP, you cannot view the
AUX input in the window picture.
Tip -Q-
Pressing ANT switches between these inputs.
If you are connecting a cable box through the AUX input and
would like to switch between the AUX and normal (CATV) input
you should consider using the CHANNEL FIX feature, (see page 23).
Cable bo.';
IN
.'Rea;- of TV)
AUX
OUT
TO CONVERTER
75-ohm'roaxial i.abU iiit^suppliecO I
(signal)
VHF/UHF
CATV cable (imscrambled channeli.)