Attaching the external antenna connector, Attaching a uhfa/hf band mixer, Ohm coaxial cable – Sony SLV-798HF User Manual
Page 83
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
General setup information (continued)
Attaching the external
antenna connector
When using a 300-ohm twin lead cable
for VHP / UHF antenna, use the EAC-32
antenna connector (not supplied) to
connect the antenna to the VCR.
300-ohm twin
lead cable
EAC-32 Antenna
connector (not
supplied)
1
Loosen the screws on the antenna connector.
2
Wind the twin leads around the screws on the antenna connector.
3
Retighten the screws.
Attaching a UHFA/HF band
mixer
When using both 75-ohm coaxial cable
and 300-ohm twin lead cable for VHP /
UHP antenna, use the EAC-66 UHF /
VHP band separator/mixer (not
supplied) to connect the antenna to the
VCR.
300-ohm twin
lead cable
EAC-66
UHF/VHF
band
separator/
.
mixer (not
I
supplied)
75-ohm coaxial
cable
1
Loosen the screws on the mixer.
2
Wind the twin leads around the screws on the mixer.
3
Retighten the screws.
4
Connect the 75-ohm coaxial cable to the mixer.
84
Additional Information