Sony SLV-798HF - Manual (Page 6)

step 2: Setting up the remote commander (continued)
Controlling other TVs with the remote commander
Tlio remote commander is preprogrammed to control non-Sony TVs. If vour TV
is listed in the table below, set the appropriate manufacturer's code number.
1 Set TV .RECEIVER/ VIDEO at the top of the remote commander toiTV!
RECEIVER.
2
Holci POWER down, and enter your TV's code number(s) using the
number buttons. Then release POWER.
Now you can use the POWER, VOL +/-, CH +1-, and TV/VIDEO buttons to
control vour TV. You can also use the buttons marked with a dot (•) to control
a Sony TV. To control the \'CR, reset TV RECEIVER / VIDECV to I VIDEO I.
Tip
• If \'ou set vour I Vs code number correclK while the 1 V is turned on, the TV turns
off automatically.
Code numbers of controllable TVs
If more than one code number is listed, tr}' entering them one at a time until
you find the one that works with your TV.
Manufacturer
Sonv
Akai
AOC
Centurion
Coronado
Curis-Mathes
Daytron
Code
number
01
04
04
12
03
12
Manufacturer
]\'C
KMC
Magnavox
Marantz
Code
number
09
03
03,08,12
04,13
Manufacturer
MGA/Mitsubishl 04,12,13,17
12
Emerson
Fisher
03, 04, 14
11
06,10
03, 04, 17
General Electric
Gold Star
Hitachi 02,03
J.C.Penny 04,12
NEC
Panasonic
Philco
Philips
Pioneer
Portland
Quasar
Radio Shack
04,12
06,19
03,04
08
16
03
RCA
Sampo
Sanyo
Scott
Sears
Sharp
Sylvania
Code
number
04,10
12
11
12
07,10,11
03,05,18
Teknika
Toshiba
Wards
08,12
03,08,14
07
06,18
05,14
Yorx
Zenith
03,04,12
12
15
Notes
• If the TV uses a different remote control system from the one programmed to work
with the VCR, you cannot control your TV with the remote commander.
• If you enter a new code number, the code number previously entered will be erased.
• When you replace the batteries of the remote commander, the code number
automatically resets to 01 (Sony). Reset the appropriate code number.
6 I Getting Started