Sony SLV-798HF - Manual (Page 8)

B Use this hookup if your TV has the S-Link^” function
VCR Stereo receiver
Note
To plii\' .1 tiipo in stereo, you must use the A/\' connection.
AIM hookup: VCR setup
After you've connected your TV and completed antenna or cable hookup,
use the following procedure to set up the VCR.
Press MENU and select
ADVANCED OPTIONS.
TIMER SET/CHECK
TUNER PRESET
CLOCK SET
LANGUAGE
SET VCR PILJS+ CHANNELS
CABLE BOX CONTROL
Use 1^ 11 0 select_________ an
item, then push 1^
Set AUTO ANT SELto
OFF and press OK.
AUTO ANT set ION OFF
AUTO STEREO ON OFF
AUDIO MIX [ on OFF
TUNER AUDIO MAIN;SAP
SHARPNESS | l - - H
Use ^1 1 0 select an
i tem. then push |»»|
For details, see page 80.
Caution
Connections between the VCR's VHF/UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure
to do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous (parallel) antenna
and VCR connections at the antenna terminals of your receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer's attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
continued
Getting Started 9