Sony STR-D711 - Manual (Page 20)

Recording an Audio Source
Recording onto an Audio Tape Deck or DAT Deck Tape Dubbing
Audio signals
1
Select the desired program source with the
function selector.
For an FM/AM broadcast, tune in the desired station
Set the tape (DAT) deck in the recording mode.
Start playback of the selected program source.
Note on recording
For TAPE 1, 2 and DAT REC OUT jacks, the settings of
SOUND FIELD and DBFS do not have any effect on
recording.
Monitoring the recorded sound
If you have connected a 3-head tape deck to the TAPE 2
jacks, you can monitor the recording results. While
recording or dubbing, press TAPE 2 MONITOR so that the
TAPE 2 MONITOR indicator lights up. To listen to the source
sound again, press the button again so that the indicator
goes off.
Audio signals
Tape deck 2
(for recording)
Tape deck 1 or
DAT deck
(for playback)
1
insert the recorded tape into tape deck 1 (or the
DAT deck).
2
insert a blank tape into tape deck 2 and adjust
the recording level.
Press TAPE 1 or DAT to select the deck for
playback.
4
Set tape deck 2 In the recording mode and then
start playback of the tape (or the DAT) on tape
deck 1 (or the DAT deck).
Dubbing will start.
Note on tape dubbing
Tape dubbing is possible only in the following directions:
From
(playback deck)
To
(Recording deck)
Tape deck
connected to
TAPE 1 IN
Tape deck connected to TAPE 2 OUT
DAT deck connected to DAT OUT
DAT deck
connected to
DAT IN
Tape deck connected to TAPE 1 or 2
OUT
Press the function selector according to the playback deck.
20