Sony STR-D711 - Manual (Page 11)

I
Chapter 2 Basic Operations
I
Operating with the Remote Commander
Before operating the equipments with the remote
commander, be sure to set the receiver to the desired mode
by pressing one of the FUNCTION buttons.
The FUNCTION buttons are factory s|et in the following list.
list of operative buttons in SYSTEM mode (When setting
the SYSTEM/TV selector to SYSTEM
FUNCTION to be
pressed Operating equipment
DAT DAT deck
CD CD player
TUNER Tuner '
PHONO (The receiver enters the PHONO mode.)
VIDEO 1 BetamaxVCR(VCRI)
VIDEO 2 LD player
VIDEOS 8 mm VCR (VCR 2)
TAPE Tape deck A
• When VIDEO 1,2 or 3 is pressed, the power of the
selected video equipment and TV i$ turned on.
Operating the equipment
1 Press the desired FUNCTION.
2 Press < (only for tape deck) or ► to start playback.
Changing the Settings of the FUNCTION Buttons
With the SELECT button, you can replace the functions
stored in the FUNCTION buttons.
To change the settings of the FUNCTION buttons
1 Press one of the FUNCTION buttons to be stored.
2 Press SELECT by using the pointed tool.
3 Press 1 to 9 button to select the desired function within 30
seconds.
To reset to the initial state, press Ihq >10 button.
With the numeric buttons from 1 to 9, the each function
can be selected as described below:
Numeric buttons
to be pressed
The function to be selected
1 CD player
2 DAT deck
3 DECK A
4 DECKB
5 TV
6 LD player
7 VTR1
8 VTR2
9 VTR3
Operating
equipment
TUNER CD DAT DECK
A.B
TV LDP VTR1,
2.3
1 • # • — • • •
2 • • • — • • •
3 ♦ • # — • • •
4 • • • — • • ♦
5 • • • — • • •
6 • • • — • • •
7 ♦ • • — • • »
8 • • • — • • •
9 ♦ • • — • • ♦
0 • • • — • • %
>10 — • — — —
• —
ENTER — — — — • • •
SHIFT •
— — — — — —
TV/VIDEO — — — — • •* ••
ANT TV/
VTR
— — — — — — •
CH
PRESET
+/-
• — — —
• — •
INDEX •
— — — — — —
D.SKIP — • — — — — —
► ► — • • • — • •
« — • • • — • •
— • ♦ — — • —
— # • — — • —
•4H-* — — — •
— — —
— — • •
— — •
II
— • • • — • •
•e — — — • — — —
► — • • • — • •
■ — • • • — • •
VISUAL
POWER
— — — —
• • •
Note
The 0 and ENTER buttons do not function.
•; The button is operative.
—: The button is not operative.
•*: The button can operate TV.
Note
To operate the unit correctly, the function mode of the
receiver should be same with that of the remote
commander. So, be sure to press the desired FUNCTION
button at first and then the operative button.