Connecting a dtv (digital television) r^eiver, Notes, Connecting a camcorder – Sony KP-61V90 User Manual
Page 18: M ^ imtauing and connecting the projecti ontinued)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
_
-
-
Disconnect all power sources before nmking any connections.
Connecting a DTV (digital television) r^eiver
^ ^
M ^ ImtaUing and Connecting the Projecti
ontinued)
Before connecting, be sure to read the Operating
Instructions of the DTV receiver.
1
Attach the coaxial cable from the roof
antenna to VHF/UHF IN (DTV) on the DTV
receiver.
2
Using AUDIO and S VIDEO cables, connect
AUDIO and S VIDEO OUT on the DTV
receiver to AUDIO and S VIDEO IN on the
projection TV (White-AUDIO Left, Red-
AUDIO Right).
Notes:
• Your DTV receiver must be able to support
4801 video format output.
• If your DTV receiver supports 4801 signal
from
YP
b
P
h
,
you can connect
Y, P
b
and
P
h
of
VIDEO OUT on the DTV receiver to
Y, P
b
and
P
r
of VIDEO 4 IN on the projection TV
using VIDEO cables.
Connecting a camcorder
Use this connection to view a picture directly
from your camcorder.
1
Using AUDIO and S VIDEO* cables, connect
AUD!
o
and S VIDEO OUT on the camcorder
to AUDIO and S VIDEO IN Inside the drop
down panel on the front of the projection TV
(White-AUDIO Left, Red-AUDIO Right**).
2
Press VIDEO 2 to select the video Inputs
from a camcorder.
• ir your camcorder is not equipped with S VIDEO,
use a VIDEO cable (yelkmj instead of the S VIDEO
cable,
** If you are connecting a monaural camcorder,
connect only the single audio output to the left
(MONO) input on the projection TV.
14
S ViOEO
{Rear of proieetion TV)
YC-lS¥/3li¥ fnsl »uppli^iii
m
BT¥ resesver
Koof antersiia
KK-
jpliedl
□
¥C"15¥/3{}¥ fsiol aippliedi