Advanced operations, Sing alternate power sources, Te on power sources – Sony CCD-TRV30 User Manual
Page 12: Using house current, Warning, Precaution, Notes on the power lamp, To remove the adaptor, Using a car battery, To remove the dc pack
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advanced Operations
r
sing Alternate Power Sources
u can choose any of the following power sources for your camcorder: battery pack (p.6), house
; rent, and 12/24 V car battery. Choose the appropriate power source depending on where you want
use your camcorder.
lace
Power source
Accessory to be used
idoors
House current
AC power adaptor AC-V26(supplied), AC-SIO, AC-V55
utdoor
Battery Pack
Battery pack NP-66 (supplied), NP-98/98D, NP-80/80D,
NP-68, NP-C65, NP-60D
1
the car
12 V or 24 V car battery
DC pack DCP-77
)te on power sources
sconnecting the power source or removing the battery pack during recording or playback may
mage the inserted tape. If this happens, restore the power supply again immediately.
Using House Current
) use the supplied AC power adaptor:
) Lift up the viewfinder.
;) Connect the power cord to a wall outlet. Connect the bottom of the AC power adaptor to the
battery mounting surface of the camcorder.
!) Set the selector to VTR (DC OUT).
WARNING
Power cord must only be changed at qualified service shop.
PRECAUTION
The unit is not disconnected from the AC power source as long as it is connected to the wall outlet,
even if the set itself has been turned off.
Notes on the POWER lamp
• The POWER lamp will remain lit for a while even if the unit is unplugged after use. This is normal.
• If the POWER lamp does not light, set the selector to the center position and disconnect the power
cord. After about one minute, reconnect the power cord and set the selector to VTR (DC OUT) again.
To Remove the Adaptor
The adaptor is removed in the same way as the battery pack (p,8).
Using a Car Battery
Use the DCP-77 DC pack (not supplied). Connect the cord of the DC pack to the cigarette lighter socket
of a car (12 V or 24 V). Connect the DC pack to the battery mounting surface of the camcorder.
To Remove the DC Pack
The DC pack is removed in the same way as the battery pack, (p.8)
Options for Charging the Battery Pack
AC-SIO AC power adaptor:
You can charge a battery pack whether it is used up or not with this adaptor because it has a
discharging function.
This mark indicates that this product is a genuine product related to our 8mm
video equipment.
When purchasing out 8mm video equipment, we recommend that you purchase
related 8mm video products provided with the same mark or products provided
with our logotype mark.
23