Specifications, Additional information – Sony STR-DE905G User Manual
Page 48
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Additional Information
Specifications
Audio power specifications
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION
With 8-ohm load, both
channels driven, from 20 -
20,000 Hz, rated 120 watts
per channel, minimum RMS
power, with no more than
0.3 % total harmonic
distortion from 250
milliwatts to rated output.
Amplifier section
POWER OUTPUT
inputs
Sensitivity Impedance S/N
(weighting
network,
input level)
PHONO 2.5 mV
(MM)
50 75 dB*"^
kilohms (A, 2.5 mV)
CD 200 mV
TAPE,
150
mV
OAT/MD,
VIDEO 1.
2, 3. TV/
DBS, LD
50 82 dB**
kilohms (A, 250 mV)
Stereo mode
8 ohms 20 Hz - 20 kHz,
BASS BOOST
+10 dB at 70 Hz
120W-t-120W
TONE
±8 dB at 100 Hz
Surround mode
8 ohms at 1 kHz,
and 10 kHz
THD 0.8 %
FM tuner section
Terminals
Output
Tuning range
87,5- 108.0 MHz
Front
120 W/ch
Antenna
75 ohms, unbalanced
Center
120 W
terminals
Rear
50 W/ch
Sensitivity
Mono: 18.3 dBf, 4.5 pV
Stereo: 38.3 dBf, 45 pV
Dynamic power
160 W -t- 160 W, 8 ohms
Usable sensitivity
11,2 dBf, 2 pV (IHF)
output
225 W + 225 W, 4 ohms
S/N
Mono: 76 dB
Harmonic
Less than 0.3 '•7
Stereo: 70 dB
distortion at
rated output
Harmonic
Mono: 0.3%
distortion at
Stereo; 0.5 %■
Frequency
PHONO: RIAA
1 kHz
response
equalization curve
±0.5 dB
Separation
45 dB at 1 kHz
CD, TAPE, DAT/MD,
TV/DBS, LD, VIDEO
Frequency
30 Hz-15 kHz‘"'dB
1,2,: 10 Hz-50 kHz ;“dB
response
(IDirect Pass)
Selectivity
60 dB at 400 kHz
Tuning range
With 10 kHz interval*:
530- 1710 kHz
With
9
kHz interx-al:
531 -1710 kHz
AM tuner section
Antenna
Loop antenna
Usable sensitivity
50 dB/m (at 1,000 kHz or
999 kHz)
S/N
Harmonic
distortion
Selectivity
54 dB (at50mV/m)
0.5% (50 mV/m,
400 kHz)
At 9 kHz: 35 dB
At 10 kHz: 40 dB
** 78 IHF
Outputs
REC OUT VIDEO 1,2
(AUDIO) OUT:
Voltage 250 mV,
Impedance 10 kilohms
WOOFER OUT
Voltage: 2 V
Impedance: 1 kilohms
PHONES: Accepts low
and high impedance
headphones
You can change the AM tuning interval
between 9 kHz and 10 kHz. After tuning
in any AM station, turn off the receiver.
Hold down the PRESET + button and
press the POWER button. All preset
stations will be erased when you change
the interval. To reset the interval, repeat
the procedure.
Video section
Inputs
Outputs
General
System
Power
requirements
Power
consumption
AC outlets
VIDEO 1,2, TV:
1 Vp-p 75 ohms
VIDEO 1,2, MONITOR:
1 Vp-p 75 ohms
Tuner section: PLL
quartz-locked digital
synthesizer system
Preamplifier section;
Low-noise NF type
equalizer
Power amplifier section:
Pure-complimentary
SEPP
120 V AC, 60 Hz
USA model; 270 W
Canada model: 400 VA
2 switched, total 120 W
Dimensions
17x6 V« x 14 V« inches
(430 X 160 X 365 mm)
Mass (Approx.)
10.0 kg (22 lb 1 oz)
Supplied
accessories
FM wire antenna (1)
AM loop antenna (1)
Remote commander
(remote) (1)
Size AA (R6) batteries (2)
RC antenna
(STR-DE905G only)0)
IR repeater (1)
Geting Started and Basic
Operation Guide (1)
Design and specifications are subject to
change without notice.
48