Adjusting the sensitivity of the remote, Settings and adjustments – Sony STR-DE905G User Manual
Page 42
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Settings and Adjustments
Adjusting the Sensitivity of the
Remote
Selecting the Display
Param eters
You can select from five different sensitivity levels that
determine the speed at which the pointer moves.
1
Click FUNCTION in the main menu.
The FUNCTION SELECT menu appears.
2
3
Click SETUP.
Click FEELING 1 through 5 to select the
sensitivity level you desire.
The higher the number, the faster the speed.
■ AUTO PLAY
■ FLASHER
■ IR OUTPUT
■ AUTO OSD ERASE
■ POINTER ONLY
■ DEMO
■ DISPLAY
■
k
FEELING
I 1
2n3 4 5
I
tl
returi
TI
ft I» E>
To return to the main menu
Click EXIT.
To go to the previous menu
Click RETURN,
Note (STR-DE905G only)
If \’ou find it difficult to ciiange the remote commander
sensiti\'it\' because the setting is too high (i.e., 5), turn off the
unit: then turn it on while holding down the CD and
PHONO buttons on the front panel.
The remote commander sensitivity will return to the factory-
set value.
Use this procedure to select one of two display types;
NORMAL or SEE-THROUGH, and one of three
display modes: AUTO OSD ERASE, POINTER ONLY,
or DEMO.
It also allows you to switch the IR OUTPUT setting
when you use the IR repeater.
1
Click FUNCTION in the main menu.
The FUNCTION SELECT menu appears.
2
Click SET UP.
3
Click DISPLAY NORMAL or SEE-THROUGH to
select the display type.
SET UP
■ AUTO PLAY
■ FLASHER
■ IR OUTPUT
■ AUTO OSD ERASE
■ POINTER ONLY
■ DEMO
■ DISPLAY
NORMAL
■
k
FEELING
I
^ RETURN I
%
SEE-THROUGH
NORMAL: The display appears in the factory-set
color.
SEE-THROUGH: All menus and control panels
are transparent, with i)nly characters and outlines
visible, allowing you to see the contents of video
and laserdisc programs.
Note
Even if you ha\'e selected SHE-THROUGH, the display
changes to NORMAL when there is no \ ideo signal
being input. When a video signal is input, the display
reverts to SEE-THROUGH.
Click AUTO OSD ERASE ON or OFF, POINTER
ONLY SET or DEMO START to select the display
mode as necessary.
If necessary, dick IR OUTPUT ON or OFF.
■ AUTO PLAY
■ FLASHER
■ IR OUTPUT
• AUTO OSD ERASE
■ POINTER ONLY
■ DEMO
■ DISPLAY
■
k
FEELING
I
U RETURN I
ON
OFF
ON
OFF
SET
START
42