Sony STR-DE905G - Manual (Page 14)

Preparing and Using the Remote
Inserting Batteries Into the
Remote: STR-DE905G
1 Open the cover on the bottom of the remote.
2 Insert tw’o size -AA (R6) batteries with correct
3 Close the cover by holding it down (it will be a
little uneven) and turning it to the right.
The cover locks
After inserting the batteries into the remote
Place it undisturbed on a flat surface for about 10
seconds to a!lov\’ the inlenial circuitry to calibrate.
Inserting Batteries Into the
Remote: STR-DE805G
1 Open the cover on the bottom of the remote.
2 Insert two size -AA (R6) batteries with correct
polarity {+/-).
To avoid damage caused by battery leakage and
corrosion
Romoc'e the batteries when the commander will not be
used for a long time.
14
'Ç' To avoid damage caused by battery leakage and
corrosion
Remove the batteries when the commander will not be
used for a k'ng time.
Battery life
• .Normal operatitm can be expected about three
months using Sony SUM-3 (NS), and a half year
using Sony AM-3 (NW) alkaline batteries. Since the
remote consumes power whenever you pick it up
and an on-screen ciisplay appears, the service life of
the batteries mav be less than three months,
depending tm how much vou handle the remote.
• When the batteries become weak, LOW will appear
on the display during the initial on-screen displa\ <
(but possibly nth at the deeper menu levels). When
LMPTY appears, tlu' batteries are almost compieteK
drained and will soon need to be replaced.
Battery life
• Normal operation can be expected about three
months using Sony SUM-3 (NS), and a half year
using Sony AM-3 (NW) alkaline batteries. Since the
remote consumes power whenever you pick it up
and an on-screen display appears, the service life of
the batteries may be less than three months,
depending on how much you handle the remote.
• Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a
malfunction.