Sony STR-DE905G - Manual (Page 2)

W ARNING
- Consult the dealer or an experienced
radio/TV technician tor help. Precautions
To prevent fire or shock
hazard, do not expose
the unit to rain or
moisture.
A
This symbol is intended to alert the user
to the presence of uninsulated
"dangerous voltage" within the
product's
enclosure that may be of sufficient
magnitude to constitute a risk of electric
shock to persons.
This symbol is intended to alert the user
to the presence of important operating
and maintenance (servicing)
instructions in the literature
accompanying the appliance.
IMPORTANT
This equipment has been tested and
found to complv with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This ec]uipmer>t generates, uses, and can
radiate radio frequence energy and, if
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or telex'ision
reception, u hich can be determined by
turning the equipment oft and on, the
user is encouraged to try to correct the
interference by one or metre of the
following measures:
- Reorient I'r relocate the receiving
antenna.
- increase the separation between the
equipment and receic t'r.
- Ci>nnect the equipment into an outlet
on a circuit different trom that to
which the receu'er is connected.
CAUTION
You are cautioned that any change or
modifications not expressly approved in
this manual could void \ our authi^rity
to operate this equipment.
Note to CATV system installer
This reminder is provided to call the
CATV system installer's attention to
Article 820-40 of the NEC that provides
guidelines for proper grounding and, in
particular, specifies that the cable
ground shall be connected to the
grounding system of the building, as
close to the point of cable entry as
practical.
Note on the remote commander:
This device complies with Part 1.^ of the
FCC Rules. Operation is subject to tire
following two conditioits: (I) This
device may not cause harmful
interference, and (2) this de\'icc must
accept any interference rocei\’ed,
including interference that ma\' cause
undesired operation.
CAUTION
Use of this appliance with some s\ stem.''
may present a shock i,'>r fire hazard Do
not use with any units which ha\ o the
following marking located near output.
WARNING: HAZARDOUS ENERGY '
Owner's record
The model and serial numbers are
located on the rear ol the unit. Record
the serial number in the space pro\ ided
below. Refer to them \\'honever wni call
upon your Son\' dealer regarding this
product.
Model No. STR-DE903t;;/STR-DES0SC;
Serial xNo. _______________
For the customers in Canada
CAUTION
TO PREVENT ELECTRIC' SHOCK, DO
NOT USE THIS POLARIZED AC I’LUG
WITH AN EXTENSION CORD,
RECEITACLE OR OTHER OUTLET
UNLESS THE BLADES CAN BE EL LIA'
INSERTED TO PRE\'ENT BLADE
EXIN)SURE
This class B digital apparatii> meets all
requirements the Lan.idian
Interferen<.‘e-(- ausing I-\|uipment
Regulations.
On safety
• Should any solid object or liquid fall
into the cabinet, unplug the receiver
and have it checked by qualified
personnel before operating it any
further.
On power sources
• Before operating the receiver, check
that the operating voltage is identical
with your local power supply. The
operating \'oltage is indicated on the
nameplate at the rear of the receiver.
• This unit is not disconnected from the
AC power source as long as it is
connected to the wall outlet, even if
the unit itself has been turned off.
• If you are not going to use the
receiver for a long time, bo sure to
disconnect the receiver from the wall
outlet. To disconnect the AC pt)wer
cord, grasp the plug itself; never pull
the cord.
• One blade ot the plug is wider than
the othiM' for the purpose of safety
and u’ill tit into the wall outlet only
one wav. If vou are unable to insert
the plug tullv into the outlet, contact
your dealer.
• AC powt'r cord must be changed
only at the qualilied service shop.
On placement
• Do not install the appliance in a
confined space, such as a bookcase or
built-in enbinet-
• I’lace the receiver in a location with
adequate ventilation to prevent heat
buildup and prolong the life of the
receiver.
• Do rmt place the receiver near heat
seHirces, cir in a place subject to direct
sunlight, excessive dust or
mechanical shock.
• Do not place anything on top t)f the
cabinet that might block the
ventilation holes and cause
malfunctions.
On operation
• Before connecting other compiinents,
be sure to turn off and unplug th<>
receiver.
On cleaning
• (. L'an the cabim't, panel .md controls
with a soft cloth slightly moistened
with
<1 mild detergent solution. Do
not U'--e am’ Ivpe ot abrasu’C pad,
scduring powder cir salcohol or benzine.