Sony DHC-MD333 - Manual (Page 46)

4
Press ENTER/YES.
The cursor starts flashmg.
Labelling the preset station
(continued)
Cursor
Press CHARACTER repeatedly
until the type of character you want
appears.
Each time you press the button, the
display changes as follow:
A (Upper case) —► a (Lower case) —► 0
(Numbers) —► ! (Symbols)*
-+ (Space)** —»A...
* You can use the following symbols.
!"#$%&■()*+
** To enter a space
Go to the step 6. You cannot label a
blank space for the first letter.
6 Press + /- repeatedly until the
desired character appears.
7
Press CURSOR
The character you selected in step 6 stops
flashing and the cursor shifts to the right.
9
Press ENTER/YES to complete the
labelling procedure.
To cancel labelling
Press EDIT.
To check the titles
Press DISPLAY.
Each time you press the button, the display
changes as follows:
The station name ► Frequency
To erase the name
Start over from steps 1 through 5 and press
CANCEL/NO repeatedly until the label
disappears.
Cursor
8
Repeat steps 5 through 7 to
complete the entire title.
If you enter an incorrect character, press
CURSOR ^ or ^ until the character
you want to change flashes, then repeat
steps 5 through 7. To erase a character,
press CANCEL/NO while the character
is flashing.
46