Sony CDP-CX350 - Manual (Page 8)

Getting Started
3
Movo the cursor to "Memo loiiding/' then pres
the liasv scroll key.
► A l I m e m o d a t a
M a s t e r p I a y e r
G r o u p m e m o
when you connect another CD player, "2nd
player" also appears.
When you want to load all Disc Memos (the master
player’s, secondiZD player's^ and both player's
Group Memo data), move the cursor to
"All memo data," then press the Easy scroll key.
The remote starts reading all memo data. The
loading time may take a few moments. Point the
remote at the player while loading the data.
* The second CD player's Disc Memo data must be
loaded to the master player before you load the
data to the remote.
Keep the remote 1 - 2 m away from the player while
loading the data.
/er M a s t e r p l a v i
m e m o L O A D I N G
DISCUO^BZZ
when you want to load each Disc Memo data
independently, move the cursor to the data you
want to load, then press the Easy scroll key.
5
When the remote finishes reading the 3ata,
"Memo loading complete" appears in the remote's
display.
Adjusting the display contrast of the
remote
1
Press MENU.
► M e m o s e a r c h
P r o g r a m p l a y
P r o g r a m i n p u t
G r o u p s e l e c t
2
Move the cursor (►) to "Set up" by using the Easy
scroll key, then press the Easv scroll key.
► P l a y e r c h e c k
M e m o l o a d i n g
C o n t r a s t a d j u s t
M e m o r y c l e a r
3
Move the cursor to "Contrast adjust," then press
the Easv scroll kev.
C O N T R A S T
c o n t r a s t
A D J U S T
a d j u s t
4
Adjust the contrast by pressing the Easy scroll key
up or down and holding until the desired level of
contrast is attained.
5
Press the Easv scroll kev.
Turning off the LCD back light
You can conserve the remote's power by turning off
the LCD (Liquid Crystal Display) back light.
1
Press MENU.
► M e m o s e a r c h
P r o g r a m p l a y
P r o g r a m I n p u t
G r o u p s e l e c t
2
Move the cursor (►) to "Back light mode" by using
the Easy scroll key, then press the Easy scroll key.
L C D B a c k l i g h t
► O N
O F F
3
Move the cursor to "OFF," then press the Easy
scroll kev.
Note
If vou erase ail the data stored in the remote (page 9). tollou-
the procedure above to turn the back light off again .