How to use the cd booklet holder, Inserting batteries into the remote, Notes – Sony CDP-CX350 User Manual
Page 4: Hooking up the system, Overview, What cords will i need, Unpacking, Getting started
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting Started
Unpacking
Chock tliat \4ui roooivod iho following iloms;
• Audio cord (1)
• CD booklet holders (3) and label (!)
• Remote commander (remote) (1)
• Size AA (LR6) batteries (3)
How to use the CD booklet holder
The CD booklet holder helps you locate discs easih'.
After vou ha\’o inserted discs into the pla\’or, \ ou can put
the CD booklet (which comes with a CD) into the
supplied holder. Put two CD booklets facing back to back
into a pocket. Stick (lie number label on each pocket,
matching the number of the disc slot u here you ha\ e
inserted the disc. You can put up to 300 CD booklets into
the holders.
Inserting batteries into the remote
You can control the player using the supplied remote.
Insert three size AA (LR6) batteries (supplied) by
matching the + and - ends on the batteries to the
diagram inside the battery compartment.
Insert the negative (-) end first, then push in and down
until the positive (+) end clicks into position.
When using the remote, point it at the remote sensor S
on the player.
If batteries with new alkaline batteries. Use of battery types other than alkaline batteries, such as manganese batteries, may not last longer than the alkaline batteries. The loaded memory in the remote will be retained for a few minutes while you replace the batteries. Notes place. • Do not drop any foreign object into the remote casing, particularly when replacing the batteries. • Do not expose the remote sensor to direct sunlight or leave too near lighting apparatuses. Doing so may cause a maltunction. • If you do not use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion. Hooking Up the System Overview This section describes how to hook up the CD player to an amplifier. Be sure to turn oft the power of each component before making the connections. CONTROLAI II DIGITAL OUT What cords will I need?
• Do not leave the remote near an extremely hot or humid
(OPTICAL)
Audio cord (1) (supplied)