Troubleshooting, There is no sound, The cd does not play – Sony CDP-CX350 User Manual
Page 41: The remote does not function, The player functions incorrectly, Supplied accessories, Specifications, Additional information
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Additional Information
Troubleshooting
It \4Hi oxpolionce
¿илу
ot the toliow in^ ditticiilties while
usiiii; the plaver, use this troubleshooting guide to help
vou remociv the problem. Should anv problem persist,
consult your iiearest Sony dealer.
There is no sound.
^Check that the player is connected securely.
^^Make sure you operate the amplifier correctly.
The CD does not play.
^There is no CD in a slot ("-NO DISC-"
appears).
Insert a CD.
^Insert the CD with the label side facing right.
^Clean the CD (see page 40).
^Moisture has condensed inside the player. Open
the front cover and leave the player turned on
for about an hour (see page 40).
The remote does not function.
^Remove obstacles in the path of the remote and
the player.
■♦■Point the remote at the remote sensor on
the player.
^Be sure to set up the remote correctly.
^Replace all the batteries in the remote with new
ones if ^ appears in the remote's display.
The player functions incorrectly.
■♦•The microcomputer chips may be operating
incorrectly. Disconnect the AC power cord, then
connect it back to the wall outlet to reset the
player.
Specifications
Compact disc player
Laser
Sc'mici>nductt.'r laser (>. = 78t> nm)
Emission duration: continuous
Laser output
Max 44.6 pW*
*
This c*utput is flic x’alue measured at
a distance of 200 mm from tlic
objective lens surface on tlio Optical
Pick-up block with 7 mm aperture.
Frequency response
20 Hz to 20 kHz ±0.5 dB
Signai-to-noise ratio
CDP-CX555ES: More than 110 dB
CDI’-CX350: More than 108 dB
Dynamic range
CDP-CX555ES: More than 95 dB
CDP-CX350: More than ^3 dB
Harmonic distortion
CDP-CX555ES: Less than 0,003
CDP-CX350; Less than 0,0045
Channel separation
More than 100 dB
Outputs
Jack
type
Maximum Load impedance
output
level
LINE OUT Phono
jacks
2V Over 10 kilohms
(at 50 kilohms)
DIGITAL OUT Optical
(OPTICAL) output
connector
-18 dBm Wave length: 660 nm
General
Power requirements
Where purchased
Power requirements
USA
120 V AC, 60 Hz
Australia
240 VAC, 50/60 Hz
Power consumption
CDP-CX555ES: 17 W
CDP-CX350: 13 W
Dimensions (approx.)
(w/h/d)
430 X 189 X 484 mm (17 X 7 1 /2 X 19 in.)
inch projecting parts
Mass (approx.)
CDP-CX555ES: 9.0 kg (19 lbs 14 o?)
CDP-CX350: 8.5 kg (18 lbs 12 oz)
Supplied accessories
See page 4.
Design and specifications are subject to change without notice.
41