Sony CDP-CX350 - Manual (Page 6)

Getting Started
Turning off the player's response to remote
signals
To uso tlio remote supplied with tinother component
compatible with the 2 way remote system, you must
turn oft this player's response to signals of the remote
supplied with this player.
Set the 2 way remote system to off when:
• you use the remote as RM-TP501, RM-TP501E,
RM-L1301 supplied with the receiver/ampiifier (you
can operate Disc 1 to Disc 200 only).
• you use the remote with the igpi mark supplied with
the receiyer/amplifier.
MENU/NO YES JOG
■
©
OCD C3 O
c53C3e=ez3
Pi 1^ . 1 .1 ■ 1
9 O « 0 0
O '-----------------------' ^----------------------------- =
1
Press MENU/NO.
2
Turning the JOG dial until "2WAY OFF ?" appears
in the display window.
3
Press YES.
When you connect the player to CDP-CX260 or CDP-
CX88ES, press OPERATE on the transmitter/receiver
to turn it off, and set the 2. way remote system of the
player to on.
To return to normal setting
After following steps 1 and 2, and "2WAY ON ?" is displayed,
then press YES.
Notes
• When you use the remote to operate more than one unit,
position the units so that each unit can receive the signals of
the remote.
• When you use this player with a receiver/ampiifier, turn
the receiver/ampiifier on when using this player.
Setting Up the Remote
This section describes how to prepare the supplied
ronrote for operation.
Press I / (!) on the player to turn the player on.
If the following message appears in the remote's
display while setting up the remote, point the remote
at the player as illustrated below.
C a n ' t r e c e i v e
P I e a s e t u r n
t h i s REMOTE
t o a m a i n u n i t
Note that the display disappears automatically if you
don't proceed for more than a few moments.