Sony RM-V10A - Manual (Page 14)

Troubleshooting
If you^ having proMMiu Mtting up or iMtog tiM
Ramota Commindan
■ When setting iq> the Cbomiandcr, eaiefaUy gd throu^ the
prooeduzes described under'*Set^ the on page & II the
code that's listed first for your component doesn't woiK try all Bw
codes for ymir component—In the order in which they're liated. 1/
aU ttte co^ Ml to woik (or if your component is not listed in this
manual), try using the procedures under '’Searching for the Correct
Code” on page 8. If, aftw trying all this, yon shO cannot get the
Commander to operate property, see‘'Customer Support
Infoanation'' below.
S Chedr dttt you're Bbtdng dre Commander cUreedy at the
component and drat duo« are no obsiructiora between the
Commander and the component.
■ Make sure die batteries you're usitig ate not worn out; and that
they're inserted correct^. Note diat whenever you remove dw
batteries — to replace dwm, for example—the code numbers
you've set are automstieatly erased and must bs reset.
■ When using the COmnumder, note that some buttons work
exdusivdy widi spedfle components. Ihese buttons also function
indepetulent of die posidon the slide switch. For example, you
can use die tape transport buttons to control the VCR even if the
sUde switch is set tolVor CABLE, Bor a con^lete Bst of the
buttons that work independendy, see die hi^iU^ted buttons in the
table on pages 10 duot^h IL
Customer Support Infonnntion
If—after you've read dirou^ this manual—you a till cannot get the
Reotote Commander to woric properly, call die Sony Customer
Sqrport Helpline at 1- 800^-2217.
14