Installing the lithium batteries, To remove the battery pack, The switch on the battery pack – Sony CCD-TR500 User Manual

Page 5: Warning, Installing ths lithium battsry into the d№wottier, To remove the lithium battery

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Charging and Installing the NP-500 Battery Pack

Installing the Lithium Batteries

To Remove the Battery Pack

Pointing down the lens of the camera, slide the ВАТТ (battery) release key upward.

The switch on the battery pack
This switch is provided to help you remember the charging status of the battery Set the switch to the “green
mark" position after charging. (When detached from the AC power adaptor, the switch exposes the green
mark. When detached from your camcorder, no mark is indicated.)

Your camcorder is supplied with two lithium batteries. One is for the camcorder, ar>d the other is for the

Remote Commander. Note that the lithium battery has a positive (+) and a negative (-) terminal as illustrated.
Be sure to install the lithium battery so that terminals on the battery match the terminals on the

camcorder or the Remote Commander.

WARNING
The battery may explode if mistreated. Do not recharge, disassemble, or dispose of in fire

Caution
Keep the lithium battery out of the reach of children. Should the battery be swallowed, consult a doctor
immediately.

Installing ths Lithium Battsry Into the d№wOttier

To activate the clock and the world clock, you must insert a lithium battery.

(1)

Turn the viewfinder up and open the lid of the battery compartment. (2) Install the lithium battery with tl

positive (+) side facing out. (3) Close the lid.

--------------\ni

Ail ".-J \

To Remove the Lithium Battery

Push the Battery down once and pull it out from the holder.
When replacing the lithium battery, keep the battery pack or other power source attached. Othenvise, you will
need to reset the date and time.