Sony CCD-TR400 - Manual (Page 18)

■ AQvancea uperaiions i
Using Alternate Power Sources
You can choose any of the following pwwer sources for your camcorder: battery pack (p.6), house
current, and 12/24 V car battery. Choose the appropriate power source depending on where you want
to use your camcorder.
Place Power source Accessory to be used
Indoors House current
AC power adaptor AC-V25/V25A/V25B/V25C
(supplied), AC-SIO, AC-V55
Outdoor Battery Pack
Battery pack NP-55 (supplied), NP-80, NP-80D, NP-77H,
NP-66H, NP-60D, NP-55H
In the car 12 V or 24 V car battery DCpackDCP-77
Using House Current
To use the supplied AC-V25/V25A/V25B/V25C AC power adaptor:
(1) Lift up the viewfinder.
(2) Connect the AC power cord to a wall outlet. Connect the bottom of the AC power adaptor to the
battery mounting surface of the camcorder.
(3) Set the selector to VTRfDC OUT).
Notes on the POWER lamp
• The POWER lamp will remain lit for a while even if the unit is unplugged after use. This is normal.
• If the POWER lamp does not light, set the selector to the center position and disconnect the power
cord. After about one minute, reconnect the power cord and set the selector to VTRfDC OUT) again.
To remove the adaptor
The adaptor is removed in the same way as the battery pack (p.8).