Transferring a message, Storing the transfer destination number, Continued – Sony SPP-A900 User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Transferring a message
After recording each incoming call, the unit transfers the calls to a
stored destination number automatically and notifies that there is a
new incoming message.
To use this function, you need to store the phone number.
Storing the transfer destination number
1
Press ( FLASH/REMOTE ).
The TALK/BATT lamp lights up in
red.
2
3
Press (
SPEED DIAL7PGM ).
Enter the phone number you want to
transfer.
You can enter up to 32 digits
including a tone, and a pause, each
of which is counted as one digit.
Press (
SPEED DIAL/PGM ).
A long confirmation beep sounds
and the destination number is stored.
Press (
FLASH/REMOTE ).
The TALK/BATT lamp goes off
Make sure that the RING ON/BATT SAVE switch is set to RING ON.
If two minutes have passed during operation, the setting is canceled. Try again
from the beginning.
continued
Using as a telephone answering machine I 35™