Trail Tech HONDA DIGITAL FAN KIT 732-FN6 - Manual (Page 2)

Zip tie the wire to the coolant outlet pipe. (See photo to right)
IMPORTANT: FILL THE RADIATOR BACK UP WITH THE CORRECT AMOUNT AND
TYPE OF COOLANT (SEE VEHICLE MANUAL).
6.) Install the power harness. Route the harness along the frame from
the fan kit to the battery. For a clean installation, the positive harness
ring terminal can be routed inside the positive battery terminal
protective rubber boot and bolted to the positive terminal.
(See below)
For CRF 250X models only:
Reinstall air suction valve (if applicable). Reinstall factory harness connectors on to bracket.
You will need to bend the bracket slightly to clear the fan kit.
7.) Reinstall fuel tank, seat, and radiator shroud.
CHANGING TEMPERATURE UNITS AND FAN SETTING:
SETTING MENU
To enter set up menu, press and hold blue button for 3 seconds.
Release when all LCD segments flash on.
SET TEMPERATURE UNIT
Select Fahrenheit or Celsius by pressing blue button.
Note: You must adjust the fan on temperature if you
change the temperature units.
TEMPERATURE SETTING
After temperature unit is selected, wait 5 seconds and the word
“Hi” will display. Press and hold blue button to increment or
decrement fan on unit. Arrow in lower left corner indicates direction
of adjustment. The direction of adjustment will change automatically in 3 seconds if button is not pressed.
After 3 more seconds the meter will automatically exit setup mode and resume current temperature display.
Page 2 of 2
Disclaimer: Trail Tech’s Fan Kit does not guarantee your vehicle will not overheat. If steam is present or engine
temperature is high, please stop and wait for engine to cool. Overheating may cause engine damage.