Trail Tech KTM DIGITAL FAN KIT 732-FN4 - Manual (Page 2)

010-ELV-164
Pre-08 4-Stroke KTM Fan Kit
Tech Support: 360-687-4530
[email protected]
PRE-2008 4-STROKE KTM FAN KIT
INSTALLATION INSTRUCTIONS
STEP 5
STEP 6
Install radiator back onto the bike and then plug the
power lead from the Fan into the power wire harness
that was installed in Step 1. Then install the Radiator
Fin Temp Sensor into the radiator fins using the
provided thermal paste.
Make sure all wiring is tied out of the way to keep from
being pinched or rubbed when seat, tank, and shrouds
are installed back on the bike. Reinstall the seat, gas
tank, and radiator shrouds back on the bike. Lastly
follow the included TTV Temperature Manual to set the
TTV meter to the designed activation temperature.
STEP 4
Once bracket and fan are mounted to the radiator
install the Radiator Fin Temperature Sensor. TIP: To
Compensate for the influence of ambient air passing
across the sensor, apply thermal grease (included in
kit) into the gap between the fins of the radiator where
the sensor will be installed. It is important to place the
grease only in the gap. Grease on the surface of the
radiator will attract dirt and reduce function.