Trail Tech 100 WATT HIGH OUTPUT DC ELECTRICAL SYSTEM KIT FOR FOUR STROKE KTMS WITHOUT ELECTRIC START SR-8310A - Manual (Page 2)

KTM & HUSABERG PLUG AND PLAY
DC ELECTRICAL SYSTEM KIT
INSTALLATION CONTINUED:
STEP 3:
A. Plug either yellow stator wire to the white wire of the
wiring harness.
B. Plug the other yellow stator wire to the Reg/Rec yellow
wire.
C. Plug the Red/Yellow Reg/Rec wire to the Yellow wire of
the wiring harness.
010-ELV-44
KTM/Husaberg Reg/Rec
Tech Support: 360-687-4530
[email protected]
STEP 2 (Option 2):
Note: The 2011-2015 KTM XC-W 2-Stroke models require use
of a Reg/Rec relocation bracket. (See Fig. 1 for bracket; Fig. 5
for install.) The 2011-2015 XC 2-Stroke models do not require
the use of the relocation bracket & can mount the Reg/Rec in
the stock location using the stock fastener.
1. Mount Trail Tech Reg/Rec to relocation bracket using
M6x16mm bolts & lock nuts
2. Using stock 8mm bolt, mount relocation bracket to frame.
Note: Use stock Reg/Rec mouting point to mount relocation
bracket to frame on 2011-2015 XC-W 2 stroke models.
2011-2012 Husaberg TE 250/300 use the mounting depicted in
Fig. 4.
Fig. 5
Stock XC-W Reg/Rec mounting point
Fig. 6
Yellow wires from
wiring harness
White wires from
wiring harness
Yellow Reg/Rec Wire
Yellow Stator Wires
Red/Yellow
Reg/Rec Wire
STEP 4: Re-install the fuse removed in Step 1A.
TRAIL TECH REG/REC INSTALLED (2011-2015 XC-W MODELS)