Tomei Powered HICASS LOCK II TYPE B - Manual (Page 16)

RIGHT SIDE (THEN LEFT SIDE) SHIM INSTALLATION
① Use monkey wrenches on both nuts to hold the right
and loosen the left side. Loosen the nut about 6 mm.
WARNING
Be careful not to loosen the nut too much.
You do not want the nut to come off.
If the nut comes off, it may be impossible
to reinstall it. So never remove the nut.
※ Leave the opposite side as normal.
② Leave the other side as normal. Separate the Shims and then install as shown below.
③ S th Shi i l ith th S
※ Same for both HICAS II & Super HICAS
Hold the nut with a wrench in place to
loosen the nut on the opposite side.
6mm
Nut Cylinder
Shim
Shim
③ Secure the Shims in place with the Screws.
The HICAS II and Super HICAS, shims have
a 2-3mm larger inner diameter than the rods
cylinder bore of the Shim. This will have a
backlash, but it poses no functional problems.
16
Screw
Screw
Cylinder Rod
Play (2~3mm)
Shim