Tomei Powered FUEL PUMP RELAY HARNESS - Manual (Page 5)

5
CAUTION
■ This product is designed for competition used ONLY. Not to be used on public roads.
■ This product will change the safety characteristics of the car and should not be used on public roads.
Doing so may break your local laws.
■ This product is to be fitted by an experienced professional in a fully equipped workshop.
■ This product is to be fitted with the correct tools, protective & safety equipment. Failure to do so can lead
to possible work hazards.
■ Refer to the vehicles original workshop service manual when disassembling the engine.
■ This product was specifically designed to be application specific. This is not a universal product.
If installed on any other vehicles/engines, this product may sustain damage and/or cause engine failure.
■ This product is to be installed when the engine is cold to prevent risk of burns.
■ Do not use excessive force when removing and installing parts. As this may cause damage to the parts
and related components.
■ This product is designed to be used with the Tomei ECU.
DANGER
■ A short circuit or fire hazard is a possible risk if the product is incorrectly installed.
Carefully read this manual and only proceed with the installation if you are confident with the work required.
KIT CONTENTS
Below is the contents of this kit, with the quantity listed in brackets ().
REQUIRED TOOLS
These tools are the bare minimum required for the job.
Male Terminal (2) Female Terminal (2)
Relay Harness
Phillips Screwdriver
Wire Stripper Crimper
Wrench or
Ratchet Wrench
Nipper