Installation verification, Warning, Caution – Tomei Powered TITANIUM AIR INTAKE PIPE User Manual

Page 7

3. INSTALLATION VERIFICATION

1. Check and verify that there is no interference with any other parts.
2. Start the engine, let it idle, then raise the rpm up to 2500 rpm whilst listening for any abnormal sounds coming
from the car.
3. Then check the car over and repeat again for the 2nd verification.

WARNING

・ When there is any loose fitting, interference. It can cause a decrease in engine/performance efficiency.
Or worse a loose item may get sucked into the turbo and cause serious damage. So please meticulously
check every part after the install.
・ If anything abnormal is found whilst driving, stop the car immediately and check the car thoroughly.
・ Do the installation when the engine bay is cold.
・ If any part(s) comes off the car, stop the car immediately and do not restart the engine. Have a qualified
experienced professional perform a safety check on your car.

CAUTION

・Continue with periodic safety checks to see if there are any loose parts after the install.