Tomei Powered N2 OIL BLOCK - Manual (Page 5)

INSTALLATION
・ Relocate the oil filter and have the oil cooler installed.
Then connect it with this product.
・ After installation, remove the spark plugs and crank the
engine to check that the oil pressure level rises.
・ Check for any signs of oil leaks. Then check oil levels.
CAUTION
■ Reuse the oil seals and O-Rings if possible. If not then replace them with brand new parts.
■ Tighten each bolt with the correct torque values as specified. Loose bolts that are not tighten enough, or are
over tightened, can damage the bolt and be dangerous.
■ Verify the correct oil pressure prior to starting the engine. Starting the engine without the preliminary safety
checks, can risk scaring the internal rotating assembly contact points and journals.
■ Check the engine oil levels, and for any signs of oil leaks before driving. If there is insufficient oil in the engine,
this can cause terminal engine failure.
Oil Seal ※Apply oil to both sides
#10 Union
Torque Settings
2.5kgm(25Nm)
Small Washer
Bolt
Torque Settings
1.8kgm(18Nm)
Large Washer
Hydraulic Pressure Switch Torque Settings 1.5kgm(15Nm)
※ Reuse the ones from the stock oil block.
※Applying sealant 1/8 Tapered Screw Plug ※ Apply sealant.
Torque Settings 1.5kgm(15Nm)
From the Oil Filter
or the Oil cooler
To the Oil Filter
or the Oil Cooler
5