Tomei Powered N2 OIL BLOCK - Manual (Page 4)

KIT CONTENTS
Below is the contents of this kit with the quantity listed in brackets ().
REQUIRED TOOLS
These tools are the bare minimum required for the job.
・General Engine Maintenance Tools ・NISSAN Workshop Service Manual ・Oil Cooler Relocation Kit
・Torque Wrench
・Oil Cooler ※
※ Please have all the additional parts required for the installation handy. This product does not include thermostat
and by pass valve. Please choose the right oil cooler that suits your car without causing any unstable oil
pressure flow.
CAUTION
■ These products are designed to be used for off road competition purposes only.
■ This product is NOT for use on public roads, due to safety risks. This product may not be road legal in your
area.
■ This product is to be installed by a qualified professional in a fully equipped workshop.
■ If the attempt was made to use this product on another engine/car other than specified then you will risk
damaging this kit and or the engine or components related with it.
■ Please periodically inspect the tightened sections.
■ Do not use any excessive force when using this product as you risk damaging the product or other parts.
■ This product is to be installed with the appropriate tools and equipment to prevent any engine failures and
injuries or bodily harm.
WARNING
■ Install the product only when the engine & drive train is cold.
■ Due to the nature of the area where the product is installed. Please exercise caution to prevent any possible
fire hazards from oil etc.
N2 Oil Block (1)
#10 Union (2)
1/8 Tapered Screw Plug (1)
Large Washer (2)
Bolt (4)
Oil Seal (2)
Small Washer (4)
4