Tomei Powered BERY RINGS - Manual (Page 4)

WARNING
■ This product is made from beryllium copper alloy. In it's normal solid state, it is safe and stable.
No special storage or handling requirements are need. Just care is required when cutting it.
＜CAUTION DANGER＞
■ Inhalation of the vapors can lead to chronic lung disease.
■Inhalation of the vapors will cause inflamation of the throat and mucous
membrane of your nasal areas.
＜DISCLAIMER＞
(Safety
■Any work that requires melting, casting, welding and dry grinding will need to be done
Measures) in a well ventilated room that meets the appropriate environmental standards.
■ Any polishing, grinding should be done when wet.
(First Aid) ■When particles are inhaled, the victim will need to be promptly be move to a safe
clean air area and seek immediate medical assistance.
■If swallowed, it can induce vomiting.
■If the particles come into contact with the skin, the affected area should be
immediately flushed with running water, then proceed with first aid proceedures.
If it cannot be washed from the affected area and there is pain, seek immediate
medical assistance.
(Storage) ■ To be storged in a dry place.
(Disposal) ■A professional qualified waste disposal company should be used when disposing of
these parts.
ASSEMBLY
CAUTION
■ This product is designed and made for competition off road use only. Not to be used on public roads.
■ This product is to be installed by a an experienced professional with a fully equiped workshop.
■ This product is made as application specific. If it is used in another engine that it is not designed for
it candamage the engine or this product.
■ Do not apply excessive force during the assembly process as you will risk damaging these or any
other related parts
4
other related parts.
■ Please use the appropriate tools and safety equipment during the installation to avoid any injuries.
■ Please do not use leaded gasoline fuel with this product as it will cause accelerated abnormal wear.
■ This product is made from beryllium (BeCu). The Beryllium sintered alloy has different thermal
expansion characteristics so the cylinder head machine process will be different. Please be sure
to match the reference value. Please follow the official service manual for reference to the other
components assembly process.
■ This product is 0.5mm oversized. Since the product is oversized the seats will need to be reseated
and matched to suit the valves.
4