Tomei Powered PONCAM/PROCAM SUPPLEMENT - Manual (Page 3)

INTAKE SIDE
VERIFY PRIOR TO INSTALLATION.
This is shipped with the cam sensor attached to the rear side of the camshaft.
Verify that the cam angle sensor pickups are all intact as shown in the illustration below.
If removed, when reinstalling the bolt,
apply thread lock paste prior to
doing up the bolt to 4.0 kgf・m
(39 N・m).
Use the stock intake cam timing sprocket
and bolt.
Remove the stock Camshaft to install the
Tomei Camshaft.
Tightening Torque
1
1
2
2
No.8
Cam
Lobe
3
Tightening Torque
6.0kgf・m (59N・m)
EXHAUST SIDE
VERIFY BEFORE INSTALLATION.
Verify that you have these parts included in the kit, Camshaft x1, Cam Gear x1,
M5 flange bolts x5.
3