Cisco 3550 - Manual (Page 78)

D-6
Catalyst 3550 Multilayer Switch Hardware Installation Guide
OL-6155-01
Appendix D Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
Step 9 Enter Y to configure the switch as the cluster command switch. Enter N to configure it as a member
switch or as a standalone switch.
If you enter N, the switch appears as a candidate switch in the Network Assistant. You can configure the
switch as a command switch later through the CLI or the Network Assistant interface. To configure it
later, enter no.
Would you like to enable as a cluster command switch? [yes/no]: no
You have now completed the initial configuration of the switch, and the switch displays its initial
configuration. This is an example of the output that appears:
The following configuration command script was created:
hostname host-name
enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1
enable password enable_password
line vty 0 15
password terminal-password
no snmp-server
!
no ip routing
!
interface Vlan1
no shutdown
ip address 10.4.120.106 255.0.0.0
!
interface FastEthernet0/1
!
interface FastEthernet0/2
interface FastEthernet0/3
!
...
!
interface GigabitEthernet0/10
!
end
Step 10 These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to use the configuration the next time the switch reboots, save it in NVRAM by selecting
option 2.
Enter your selection [2]:2
Make your selection, and press Return.