Mounting the switch on a wall, Table or shelf mounting – Cisco 3550 User Manual
Page 44
2-14
Catalyst 3550 Switch Hardware Installation Guide
OL-6155-01
Chapter 2 Switch Installation
Installing the Switch
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure that the switch is attached securely to wall studs
or to a firmly attached plywood mounting backboard. Mount the switch with the front panel facing up,
as shown in
Warning
To comply with safety regulations, mount the switches on a wall with the front panel facing up.
Statement 266
Figure 2-17 Mounting the Switch on a Wall
Table or Shelf Mounting
Follow these steps to install the switch on a table or shelf:
Step 1
Locate the adhesive strip with the rubber feet in the mounting-kit envelope. Attach the four rubber feet
to the recessed areas on the bottom of the unit.
Step 2
Place the switch on the table or shelf near an AC power source.
User-supplied
screws
User-supplied
screws
60967
MO
DE
SY
ST
EM
RP
S
STA
TU
S
UT
IL
DU
PLX
SP
EE
D
12
1
11
Catalyst 3550
2
3
4
5
6
7
8
9
10