Citizen Systems PD-04 - Manual (Page 30)

– 26 –
< When the Set-Up Item is "Print Contrast" >
print density [-2,-1,0,+1,+2] <0>
< ---------------------------- select 'YES'
density = –2 ? (YES NO)
< ----------------------------- select 'NO'
density = –1 ? (YES NO)
< ----------------------------- select 'NO'
density = O ? (YES NO)
< ----------------------------- select 'NO'
density = +1 ? (YES NO)
< ---------------------------- select 'YES'
Print density (+1) is selected.
density = +2 ? (YES NO)
< --------------------------- select 'EXIT'
IF selection
[infrared, cable]
< --------------------------- select 'EXIT'
To save the changes mode, turn the printer off.
After selecting the disable of DIP switch in VuePrint
Mode, turn the printer on.
Note:
In the case that the printer power is turned off in the middle of the set mode, the new
settings are lost and the printer returns its state before the set up mode was activated.
When the DIP switch functions are in operation or engaged by the user, those items
that are assigned by the DIP switch cannot be adjusted in the VuePrint function set
mode.
There is not a Move back function in the VuePrint function set mode, therefore if you
need to change a selection that you have made before you must start again from the
beginning.