Citizen Systems PD-04 - Manual (Page 13)

– 9 –
Power Source
Other than the AC adapter this printer can be operated with the battery pack (sold
separately). The battery pack is attached to the printer after it has been recharged using
the recharger, also sold separately.
Here we explain the usage of the Battery Pack and the Recharger, but before
actually using them, please read the User Manuals that come with the Battery Pack
and Recharger as well.
Note:
The new battery pack is uncharged. Be sure to charge it before your initial
use.
How to Recharge the Battery
1 Plug the recharger plug into an AC wall
outlet.
2 Put the battery pack in the recharger unit.
Make sure that the recharger and the
battery pack
directions> match up.
3 While pressing down on the battery pack,
slide them in the direction shown on the
map.
[ When recharge begins, the recharge lamp
(green) will start to blink. After recharging
the lamp will turn off.
n Removing the Battery Pack
You can remove the battery pack by
sliding them in the opposite direction as
the arrow on the figure above. For more
information please refer to the manual
that comes with the battery pack.