Canon BJC-50 - Manual (Page 29)

.
.
27
To connect the AC adapter
1. Plug the connector end of the AC adapter into the power connector on the right side of the printer.
2. Insert the AC adapter plug into a wall outlet.
z If the printer is not switched on and the battery requires recharging, the
CHARGE/ERROR lamp will light green and remain on to indicate that the battery
pack is recharging.
z To recharge the battery pack, switch off the printer and connect the AC adapter if it is not
already connected. When the battery pack is fully charged, the CHARGE/ERROR
lamp will go off. (p62)
Switching the printer on and off
1.
Before you switch the printer on, check the power lock switch on the right side of the printer. If the
power lock switch is in the left position, slide it to the right.
When the power lock switch is in the left position, it locks the power switch off so it cannot be switched on
accidentally during transport.
27