Dell PowerEdge C5230 - Manual (Page 78)

78 Using the System Setup Program
PEI Beep Codes
DXE Beep Codes
0xDC Reset protocol is not available
Table 2-9. PEI Beep Codes
# of Beeps Description
1 Memory not Installed
1 Memory was installed twice (InstallPeiMemory routine in PEI
Core called twice)
2 Recovery started
3 DXEIPL was not found
3 DXE Core Firmware Volume was not found
4 Recovery failed
4 S3 Resume failed
7 Reset PPI is not available
Table 2-10. DXE Beep Codes
# of Beeps Description
1 Invalid password
4 Some of the Architectural Protocols are not available
5 No Console Output Devices are found
5 No Console Input Devices are found
6 Flash update is failed
7 Reset protocol is not available
Table 2-8. DXE Phase (continued)
Status Code Description